Magnetic Nanoparticle Support with an Ultra-Thin Chitosan Layer Preserves the Catalytic Activity of the Immobilized Glucose Oxidase.

Here, we developed magnetically recoverable biocatalysts based on magnetite nanoparticles coated with an ultra-thin layer (about 0.9 nm) of chitosan (CS) ionically cross-linked by sodium tripolyphosphate (TPP). Excessive CS amounts were removed by multiple washings combined with magnetic separation. Glucose oxidase (GOx) was attached to the magnetic support via the interaction with N-hydroxysuccinimide (NHS) in the presence of carbodiimide (EDC) leading to a covalent amide bond. These steps result in the formation of the biocatalyst for D-glucose oxidation to D-gluconic acid to be used in the preparation of pharmaceuticals due to the benign character of the biocatalyst components. To choose the catalyst with the best catalytic performance, the amounts of CS, TPP, NHS, EDC, and GOx were varied. The optimal biocatalyst allowed for 100% relative catalytic activity. The immobilization of GOx and the magnetic character of the support prevents GOx and biocatalyst loss and allows for repeated use.

Highly Selective CO2 Hydrogenation to Methanol over Complex In/Co Catalysts: Effect of Polymer Frame.

The growing demand for new energy sources governs the intensive research into CO2 hydrogenation to methanol, a valuable liquid fuel. Recently, indium-based catalysts have shown promise in this reaction, but they are plagued by shortcomings such as structural instability during the reaction and low selectivity. Here, we report a new strategy of controlling the selectivity and stability of bimetallic magnetically recoverable indium-based catalysts deposited onto a solid support. This was accomplished by the introduction of a structural promoter: a branched pyridylphenylene polymer (PPP). The selectivity of methanol formation for this catalyst reached 98.5%, while in the absence of PPP, the catalysts produced a large amount of methane, and the selectivity was about 70.2%. The methanol production rate was higher by a factor of twelve compared to that of a commercial Cu-based catalyst. Along with tuning selectivity, PPP allowed the catalyst to maintain a high stability, enhancing the CO2 sorption capacity and the protection of In against sintering and over-reduction. A careful evaluation of the structure-activity relationships allowed us to balance the catalyst composition with a high level of structural control, providing synergy between the support, magnetic constituent, catalytic species, and the stabilizing polymer layer. We also uncovered the role of each component in the ultimate methanol activity and selectivity.

Naphthalene-Based Polymers as Catalytic Supports for Suzuki Cross-Coupling.

In this work, for the first time, naphthalene (NA)-based polymers were synthesized by one-stage Friedel-Crafts crosslinking. The influence of NA functionalization by -OH, -SO3H, and -NO2 groups on the polymers' porosity and distribution of the catalytically active phase (Pd) was studied. Synthesized catalytic systems containing 1 wt.% of Pd either in the form of Pd(II) species or Pd(0) nanoparticles supported on NA-based polymers were tested in a model reaction of Suzuki cross-coupling between 4-bromoanisole and phenylboronic acid under mild reaction conditions (60 °C, ethanol-water mixture as a solvent). These novel catalysts demonstrated high efficiency with more than 95% of 4-bromoanisole conversion and high selectivity (>97%) for the target 4-methoxybiphenyl.

Ni Nanoparticles Stabilized by Hyperbranched Polymer: Does the Architecture of the Polymer Affect the Nanoparticle Characteristics and Their Performance in Catalysis?

Heat-up and hot-injection methods were employed to synthesize Ni nanoparticles (NPs) with narrow size distribution in the presence of hyperbranched pyridylphenylene polymer (PPP) as a stabilizing agent. It was shown that depending on the synthetic method, Ni NPs were formed either in a cross-linked polymer network or stabilized by a soluble hyperbranched polymer. Ni NPs were characterized by a combination of transmission electron microscopy (TEM), scanning TEM, thermogravimetric analysis, powder X-ray diffraction, X-ray photoelectron spectroscopy, energy dispersive X-ray analysis, and magnetic measurements. The architecture of polymer support was found to significantly effect Ni NPs characteristics and behavior. The Ni NPs demonstrated a high catalytic activity in a model Suzuki-Miyaura cross-coupling reaction. No significant drop in activity was observed upon repeated use after magnetic separation in five consecutive catalytic cycles. We believe that hyperbranched PPP can serve as universal platform for the controllable synthesis of Ni NPs, acting as highly active and stable catalysts.

Hybrid Pd-Nanoparticles within Polymeric Network in Selective Hydrogenation of Alkynols: Influence of Support Porosity.

This work is addressing the selective hydrogenation of alkynols over hybrid catalysts containing Pd-nanoparticles, within newly synthesized hyper-cross-linked polystyrenes (HPS). Alkynols containing C5, C10, and C20 with a terminal triple bond, which are structural analogues or direct semi-products of fragrant substances and fat-soluble vitamins, have been studied. Selective hydrogenation was carried out in a batch mode (ambient hydrogen pressure, at 90 °C, in toluene solvent), using hybrid Pd catalysts with low metal content (less than 0.2 wt.%). The microporous and mesoporous HPS were both synthesized and used as supports in order to address the influence of porosity. Synthesized catalysts were shown to be active and selective: in the case of C5, hydrogenation selectivity to the target product was more than 95%, at close to complete alkynol conversion. Mesoporous catalysts have shown some advantages in hydrogenation of long-chain alkynols.

Ru@hyperbranched Polymer for Hydrogenation of Levulinic Acid to Gamma-Valerolactone: The Role of the Catalyst Support.

Hydrogenation of levulinic acid (LA) obtained from cellulose biomass is a promising path for production of γ-valerolactone (GVL)-a component of biofuel. In this work, we developed Ru nanoparticle containing nanocomposites based on hyperbranched pyridylphenylene polymer, serving as multiligand and stabilizing matrix. The functionalization of the nanocomposite with sulfuric acid significantly enhances the activity of the catalyst in the selective hydrogenation of LA to GVL and allows the reaction to proceed under mild reaction conditions (100 °C, 2 MPa of H2) in water and low catalyst loading (0.016 mol.%) with a quantitative yield of GVL and selectivity up to 100%. The catalysts were successfully reused four times without a significant loss of activity. A comprehensive physicochemical characterization of the catalysts allowed us to assess structure-property relationships and to uncover an important role of the polymeric support in the efficient GVL synthesis.

Magnetically Recoverable Nanoparticulate Catalysts for Cross-Coupling Reactions: The Dendritic Support Influences the Catalytic Performance.

Carbon-carbon cross-coupling reactions are among the most important synthetic tools for the preparation of pharmaceuticals and bioactive compounds. However, these reactions are normally carried out using copper, phosphines, and/or amines, which are poisonous for pharmaceuticals. The use of nanocomposite catalysts holds promise for facilitating these reactions and making them more environmentally friendly. In the present work, the PEGylated (PEG stands for poly(ethylene glycol) pyridylphenylene dendrons immobilized on silica loaded with magnetic nanoparticles have been successfully employed for the stabilization of Pd2+ complexes and Pd nanoparticles. The catalyst developed showed excellent catalytic activity in copper-free Sonogashira and Heck cross-coupling reactions. The reactions proceeded smoothly in green solvents at low palladium loading, resulting in high yields of cross-coupling products (from 80% to 97%) within short reaction times. The presence of magnetic nanoparticles allows easy magnetic separation for repeated use without a noticeable decrease of catalytic activity due to the strong stabilization of Pd species by rigid and bulky dendritic ligands. The PEG dendron periphery makes the catalyst hydrophilic and better suited for green solvents. The minor drop in activity upon the catalyst reuse is explained by the formation of Pd nanoparticles from the Pd2+ species during the catalytic reaction. The magnetic separation and reuse of the nanocomposite catalyst reduces the cost of target products as well as energy and material consumption and diminishes residual contamination by the catalyst. These factors as well as the absence of copper in the catalyst makeup pave the way for future applications of such catalysts in cross-coupling reactions.

Hyper-Cross-Linked Polystyrene as a Stabilizing Medium for Small Metal Clusters.

Among different polymers nanostructured cross-linked aromatics have the greatest potential as catalytic supports due to their exceptional thermal and chemical stability and preservation of the active phase morphology. This work studies the ability of hyper-cross-linked polystyrene (HPS) to stabilize small Pdn and Ptn (n = 4 or 9) clusters. Unrestricted DFT calculations were carried out for benzene (BZ) adsorption at the BP level of theory using triple-zeta basis sets. The adsorption of BZ rings (stepwise from one to four) was found to result in noticeable gain in energy and stabilization of resulting adsorption complexes. Moreover, the interaction of metal clusters with HPS micropores was also addressed. For the first time, the incorporation of small clusters in the HPS structure was shown to influences its geometry resulting in the stabilization of polymer due to its partial relaxation.

Noble Metal Nanoparticles Stabilized by Hyper-Cross-Linked Polystyrene as Effective Catalysts in Hydrogenation of Arenes.

This work is addressing the arenes' hydrogenation-the processes of high importance for petrochemical, chemical and pharmaceutical industries. Noble metal (Pd, Pt, Ru) nanoparticles (NPs) stabilized in hyper-cross-linked polystyrene (HPS) were shown to be active and selective catalysts in hydrogenation of a wide range of arenes (monocyclic, condensed, substituted, etc.) in a batch mode. HPS effectively stabilized metal NPs during hydrogenation in different medium (water, organic solvents) and allowed multiple catalyst reuses.

Mono- and Bimetallic Nanoparticles Stabilized by an Aromatic Polymeric Network for a Suzuki Cross-Coupling Reaction.

This work addresses the Suzuki cross-coupling between 4-bromoanisole (BrAn) and phenylboronic acid (PBA) in an environmentally benign ethanol-water solvent catalysed by mono- (Pd) and bimetallic (PdAu, PdCu, PdZn) nanoparticles (NPs) stabilised within hyper-cross-linked polystyrene (HPS) bearing tertiary amino groups. Small Pd NPs of about 2 nm in diameters were formed and stabilized by HPS independently in the presence of other metals. High catalytic activity and complete conversion of BrAn was attained at low Pd loading. Introduction of Zn to the catalyst composition resulted in the formation of Pd/Zn/ZnO NPs, which demonstrated nearly double activity as compared to Pd/HPS. Bimetallic core-shell PdAu/HPS samples were 3-fold more active as compared to Pd/HPS. Both Pd/HPS and PdAu/HPS samples revealed promising stability confirmed by catalyst recycling in repeated reaction runs.

Selective Hydrogenation of Biomass-Derived Furfural: Enhanced Catalytic Performance of Pd-Cu Alloy Nanoparticles in Porous Polymer.

Here, the development of a new catalyst is reported for the selective furfural (FF) hydrogenation to furfuryl alcohol (FA) based on about 7 nm sized Pd-Cu alloy nanoparticles (NPs) formed in inexpensive, commercially available micro/mesoporous hypercrosslinked polystyrene (HPS). A comparison of the catalytic properties of as-synthesized and reduced (denoted "r") catalysts as well as Pd-Cu alloy and monometallic palladium NPs showed a considerable enhancement of the catalytic performance of Pd-Cu/HPS-r compared to other catalysts studied, resulting in about 100 % FF conversion, 95.2 % selectivity for FA and a TOF of 1209 h-1 . This was attributed to the enrichment of the NP surface with copper atoms, disrupting the furan ring adsorption, and to the presence of both zerovalent and cationic palladium and copper species, resulting in optimal hydrogen and FF adsorption. These factors along with exceptional stability of the catalyst in ten consecutive catalytic cycles make it highly promising in practical applications.